Onkyo TX-SR603X - Manual (Page 42)

42
First Time Setup —Continued
Digital Input
If you connect a component to a digital input jack, you
must assign that jack to an input selector. For example,
if you connect your CD player to the OPTICAL IN2
jack, you should assign that jack to the CD input selec-
tor. By default, the COAXIAL IN1 jack is assigned to
the DVD input selector, although this can be changed.
Initial Setup
1 Press the input selector button
for the source that you want to
assign.
(Digital inputs cannot be assigned to
the TUNER input source)
2 Press the [DIGITAL INPUT] but-
ton.
The current assignment appears.
3 Press the [DIGITAL INPUT] but-
ton repeatedly to select COAX1,
COAX2, OPT1, OPT2, OPT3, or
– – – – (analog).
• There are no assignments for
TUNER.
• VIDEO 4 is used only for digital
input from the front panel terminals.
STANDBY/ON
ZONE2
ZONE 2 LEVEL
PHONES MULTl CH
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE RETURN
TUNING / PRESET
ENTER
SETUP
DVD VIDEO 1 VIDEO 2
VCR 1 VCR 2
VIDEO 3 VIDEO 4 TAPE TUNER CD
SETUP MIC S VIDEO VIDEO
MASTER VOLUME
VIDEO 4 INPUT
L R AUDIO DIGITAL
OFF
STANDBY
CLEAR
DIGITAL INPUT
Input selector buttons
DVD VIDEO 1 VIDEO 2
VCR 1 VCR 2
VIDEO 3 TAPE
CD
DIGITAL INPUT
DIGITAL INPUT
Examples:
If you connect your DVD player to the
OPTICAL IN 2 jack, set “DVD” to
“OPT2.”
If you want to listen to audio from the
component connected to the OPTICAL
IN 3 jack when the VIDEO 1 input
selector is selected, set “VIDEO1” to
“OPT3.”
If you want to listen to audio from the
component connected to the COAX-
IAL IN 1 jack when the VIDEO 2 input
selector is selected, set “VIDEO2” to
“COAX1.”
For input selectors that you don’t want
to assign a digital input jack, set to
“---- (analog).”