Onkyo TX-SR603X - Manual (Page 78)

78
Controlling Other Components
You can use the AV receiver’s remote controller
(RC-623M) to control your other AV components,
including those made by other manufacturers.
This section explains how to:
• Enter the remote control code for a component that
you want to control (e.g., DVD, TV, VCR).
• Learn commands directly from another component’s
remote controller (see page 81).
• Program the MACRO buttons to perform a sequence
of up to eight actions (see page 82).
Entering a remote control code for a REMOTE MODE
button allows you to control an other component with the
remote controller. You’ll need to enter a code for each
component that you want to control.
Notes:
• Remote control codes cannot be entered for the
[RECEIVER], [HDD], and [ZONE 2] REMOTE
MODE buttons.
• The remote control codes provided are correct at the
time of printing, but are subject to change.
Entering Remote Control Codes
1 Look up the appropriate remote
control code in the Remote Con-
trol Codes list.
The codes are organized by category.
10 - - / - - - 11 12
REMOTE MODE
HDD RECEIVER
TAPE/AMP
DVD CD
ZONE2
SAT TV VCR CABLE
MD CDR
STEREO SURR
DIRECT
SUBTITLE AUDIO
ALLST
PLAY MODE
VIDEO OFF
REPEAT
RANDOM REC PLAYLIST
OPEN/CLOSE
CINE FLTR
+
-
T V CH
T V VOL
ENTER
SET UP
TO P M ENU MEN
U
VOL
+
-
CH
DISPLAY
PREV
CH
DIMMER SLEEP
MUTING
LISTENING MODE
INPUT SELECTOR
3 2
MACRO
1
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
INPUT I
ON STANDBY
T V
CD
V1 V2 V3
MULTI CH DVD
TUNER
DISC ALBUM
V4
TAPE
TEST TONE CH SEL LEVEL LEVEL
L NIGHT
RE TURN
RC-623M
REMOTE
MODE
TV
RECEIVER
STANDBY
I
Number
buttons
Remote
indicator
2 While holding down the REMOTE
MODE button that you want to
set, press the [STANDBY] button.
The Remote indicator lights up.
3 Within 30 seconds, use the num-
ber buttons to enter the 4-digit
remote control code.
The Remote indicator flashes twice.
4 Press the REMOTE MODE button
again to select the remote con-
troller mode, point the remote
controller at the component, and
operate it.
If the remote controller doesn’t work as
expected, and several remote codes are
listed, try each one in turn and use the
one that works best.
REMOTE MODE
DVD CD
SAT
TV VCR
CABLE
MD CDR
STANDBY
• The HDD remote mode can only be used with the
Onkyo DS-A1 Remote Interactive Dock at this
time.
• The [DVD] and [CD] REMOTE MODE buttons
are preprogrammed for use with Onkyo DVD
players and CD players respectively.
• To control another manufacturer’s CD recorder or
MD recorder, enter the appropriate control code to
the [CD] REMOTE MODE button.