OnStar 17572 R17 - Manual (Page 16)

OnStar Turn-by-Turn Navigation
Making a Wrong Turn or Making Stops During
a Planned Route
Because the OnStar Turn-by-Turn Navigation system stores the turns of your
planned route and continually checks your position along that route, when
you make a wrong turn or miss a turn, the system should recognize this. You’ll
hear a message that says “You have left the planned route, do you need
directions to get back on route? I’m listening now, please say “Yes or
No.” If, for instance, you have pulled off the highway to get lunch, and you
know that you are temporarily off the planned route, respond to the message
by saying “No.” When you return to the highway and get back to your route,
the system will recognize this and will return you to the Turn-by-Turn directions.
If you hear this message and think you missed a turn, or the road you needed
to turn on was, for instance, closed for construction, say “Yes.” The system
should automatically calculate a new route for you, (or may connect you back
to an OnStar Advisor). After a few moments, the driving instructions will begin
directing you again.
If you make a stop during your trip, you will notice that each time you start
your vehicle the system will give you a message that says “The OnStar
navigation system is now active.” This is a reminder that your planned
route is still stored and turn messages will begin to get you back on your
planned route. After you drive a short distance the system may recognize
that you are off the planned route and will ask you if you want new directions.
If you are returning to the road you were on before you went off the route,
just say “No.” The turn instructions will begin again when you return to the
planned route road. Remember, you can push the phone button and give the
“Cancel route” command to end the turn instructions.
14
17572 R17 9.28.06_singlepgs.inddSec1:16 Sec1:16 17572 R17 9.28.06_singlepgs.inddSec1:16 Sec1:16 10/5/06 2:27:31 PM 10/5/06 2:27:31 PM