Oki Pos 407II - Manual (Page 21)

–  –
4. Attaching the Accessories
The following accessories do not necessarily have to be attached.
Attach them if necessary.
• Holding plate
• Cable cover
• Switch blind
Shaft
82.5 or 79.5 mm width 57.5 mm width
4-1. Attaching the Holder Plate
() Attach the shaft to the printer.
(2) Wipe the area into which the rubber feet will be affixed in order to remove any grime; then,
affix the roll stoppers. The positions for affixing them will vary depending on the paper
width.
() Use a regular screwdriver to remove the clips at
both ends of the bar to remove the tension bar
unit.
Push in the left and
right ends of the shaft.