One for All URC-8350 - Manual (Page 8)

WWW.ONEFORALL.COM
7
The URC-8350 comes with a complete library of pre-programmed codes. After
you have set up the URC-8350 for your device, you may find that there are one
or more keys that you had on your original remote, which do not have a place
on the URC-8350 keypad.
As a convenience, the URC-8350 offers a special Learning feature that
allows you to copy any function from your original remote control onto the
keypad of the URC-8350.
Before you start:
-
Make sure your original remote control is working correctly.
- Make sure neither your URC-8350, nor your original remote control is
pointing at your device.
Example: To copy the “mono/stereo” function from your original TV
remote onto the “LAST” key of your URC-8350.
1. Place both remote controls (the URC-8350 and your original) on a flat
surface. Make sure the ends which you normally point at your device
are facing each other. Keep the remotes at a distance of 2 to 5 cm.
2. Press and hold down REWIND + FASTFORWARD
simultaneously until the URC-8350’s LED (red light)
blinks twice (the LED will blink once and then twice).
3. Press 9 7 5 (the LED will blink twice).
4. Press the device key (on the URC-8350 remote) to
select the mode to which you want to copy the learned
function (example: TV key).
5. Press the key (on the URC-8350 remote) where you
want to place the learned function (example: LAST key).
The LED will flash rapidly.
6. Press and hold the key (on your original remote) that
you want to copy until the LED on the URC-8350 blinks
twice (example: “mono/stereo” key).
7. If you want to copy other functions within the same mode, simply repeat
steps 5 and 6 pressing the next key you want to copy by learning. If you want
to copy other functions to a different mode, then repeat from step 4
onwards and press the applicable mode key.
8. To exit the learning mode, press and hold OK until the
LED blinks twice.
9. Learning is mode specific. To access your learned function, press
the appropriate device key first.
- The URC-8350 can learn approximately 25 - 40 functions (depending on the
function to be learned). Memory full will be indicated by two long blinks.
- You can replace a learned function by placing another learned function on
top.
- Upon changing the batteries, your learned functions will be retained.
The Learning Feature
(How to copy functions from your original working remote
onto the ONE FOR ALL URC 8350)
URC_8350_V_1_19feb08.qxd:Ofa5_Digital_URC7555_EURO_10_Talen 20-02-2008 16:07 Pagina 7