Onkyo TX-DS797 - Manual (Page 23)

23
• The TX-DS797 is shipped with the main power (POWER)
switch in the on position ( ON ). When the power cord is
plugged in for the first time, the TX-DS797 will automatically
enter the standby state and the STANDBY indicator will light
(same condition after step 2 below).
• Before you plug in the TX-DS797, confirm that all connections
have been made properly.
• Turning on the power may cause a momentary power surge,
which might interfere with other electrical equipment on the
same circuit, such as computers. If this happens, use a wall outlet
on a different circuit.
1. Plug the power cord into an AC wall outlet.
2. Press the ON button to turn on the
TX-DS797 (take it out of the standby
state).
To return the TX-DS797 to the standby
state, press the STDBY button.
Turning the power on from the remote controller:
Before you can use the remote controller, you must perform steps 1
and 2 above and place the TX-DS797 in the standby state.
1. Press the RCVR MODE button.
The RCVR MODE button lights green.
Memory preservation
This unit does not require memory preservation batteries. A built-
in memory power backup system preserves the contents of the
memory during power failures and even when the POWER
switch is set to off. The POWER switch must be set to on in order
to charge the backup system.
The memory preservation period after the unit has been turned off
varies depending on climate and placement of the unit. On the
average, memory contents are protected over a period of a few
weeks after the last time the unit has been turned off. This period
is shorter when the unit is exposed to a highly humid climate.
3. Press the STANDBY/ON button to
turn on the TX-DS797. The display
and four jog dial indicators will light
up and the STANDBY indicator will
turn off.
If you press the STANDBY/ON button
again, the receiver returns to Standby mode.
2. Press the POWER switch to set the
TX-DS797 to standby state.
The STANDBY indicator will light up.
To change the display of the input source from TAPE to
MD:
If you connected an MD recorder to the TAPE jack on the TX-
DS797, you can have “MD” appear when the TAPE source button is
pressed. By changing the display, if an Onkyo MD recorder z-
connected, the z system functions will become enabled.
Changing the display:
Press and hold down the TAPE source button until the display
changes from TAPE to MD (approx. 3 seconds).
To return the display to its original setting, perform the same
procedure. This setting is necessary to allow z system functions
for the connected cassette tape or MD recorder.
Connecting the power
Turn off
STANDBY/ON
OFF ON
POWER
STANDBY
PHONES
MASTER VOLUME
FM AM PHONO C D TAPE VIDEO 4 VIDEO 5 VIDEO 3 VIDEO 2 VIDEO 1 DVD
OFF ZONE 2 REC OUT DISPLAY DIMMER
UPSAMPLING
AUDIO SELECTOR
ZONE 2 ( ) GRN REC ( ) RED
S VIDEO AUDIO VIDEO L R DIGITAL
CLEAR
VCR 2 VCR 1
VIDEO 5/VIDEO CAM INPUT
DSP A-FO RM LISTENING MODE MEMORY THX SURROUND DIRECT STEREO MEMORY FM MODE
ENTER
RE TURN
SETUP TUNI NG
PRESET
AV RECEIVER TX-DS 797
ON
RCVR
POWER
TAPE
STANDBY/ON STDBY
OFF ON
POWER
STANDBY
STANDBY/ON
STANDBY
TAPE
STANDBY indicator
To wall outlet