Onkyo TX-DS797 - Manual (Page 54)

54
Enjoying music in the remote zone
Playing music using the buttons on the TX-DS797
1. Press the Zone 2 button on the TX-DS797.
2. Select a source.
After pressing the Zone 2 button, you must press an input source
button within 5 seconds. The Zone 2 indicator lights.
ZONE 2 indicator
To select the same source for the remote zone that is selected
for the main zone, press the Zone 2 button again until
“Zone2Sel:SOURCE” appears in the display.
Ex.: When the CD button is pressed.
When “Zone2Sel:Off” is displayed, the output to the remote
zone is turned off.
Notes:
• Adjust the volume for the remote zone at the pre-main amplifier.
• After you press the ZONE 2 button on the remote controller, the
STANDBY indicator on the TX-DS797 flashes for five seconds.
During this time, you will not be able to perform operations in
the main zone using the remote controller.
Selecting an input source using the remote
controller
Turning on the Zone 2 and putting it in the standby state
when the TX-DS797 is in the standby state:
After pressing the ZONE 2 button, press the ON/STDBY button
within 5 seconds.
Selecting an input source:
After pressing the ZONE 2 button, press an input source button
within 5 seconds.
If tuner is selected with the TUN button, the CH button becomes
enabled.
ZONE 2
STANDBY/ON
OFF ON
POWER
STANDBY
PHONES
MASTER VOLUME
FM AM PHONO C D TAPE VIDEO 4 VIDEO 5 VIDEO 3 VIDEO 2 VIDEO 1 DVD
OFF ZONE 2 REC OUT DISPLAY DIMMER
UPSAMPLING
AUDIO SELECTOR
ZONE 2 ( ) GRN REC ( ) RED
S VIDEO AUDIO VIDEO L R DIGITAL
CLEAR
VCR 2 VCR 1
VIDEO 5/VIDEO CAM INPUT
DSP A-FO RM LISTENING MODE MEMORY THX SURROUND DIRECT STEREO MEMORY FM MODE
ENTER
RE TURN
SETUP TUNI NG
PRESET
AV RECEIVER TX-DS 797
OFF ZONE 2
ON/STDBY
SLEEP
Input source buttons
INPUT SELECTOR
buttons
Notes:
• If a sleep time is set with the SLEEP button, it will also work for
the remote zone.
• If the source for the main zone is selected as the source for the
remote zone and the source for the main zone is changed, then
the source for the remote zone will change as well.
• The Zone 2 terminal is an analog output. Digital signals are not
output. If no sound is heard from the selected input source, check
if the component is connected to the analog inputs.
• If the REC OUT button is pressed in the main room while
someone is using the system in the remote zone, the Zone 2
function will be deactivated and the source will turn off in the
remote zone.
• If you select FM (or AM) with the input source buttons when the
source for the remote zone (Zone 2) is set to AM (or FM), the
output for the remote zone also changes to AM (or FM).
• When you are using the remote zone (Zone 2), system
operation will not work.
• When you are not using the remote zone (Zone 2), press the
ZONE 2 button and then press the OFF button to turn off the
ZONE 2 indicator.