Onkyo T-433 - Manual (Page 25)

25
Using the Timers —Continued
Notes:
• If the playback component is an MD recorder, even if
you select Memory, Random, 1GR, or another play-
back mode, normal playback will be used for timed
playback.
• Be sure to switch the system to Standby, otherwise
the timer will not be able to start playback or record-
ing.
• During timed playback or recording, you can cancel
the timer by pressing the [TIMER] button. The timer
is also cancelled if you set the sleep timer during
timed playback or recording.
6 <Set the Start Time>
Use the TUNING/PRESET
[
]/[ ] buttons (TIMER
[ ]/[ ]) to set the start time.
Press the [MEMORY] button
(ENTER).
Hints:
• When the start time is set, the end
time is automatically set to 1 hour
later.
• When recording to an Onkyo MD
recorder that’s connected to the
A-933 with an
cable, the first
several seconds may not be
recorded. To ensure that the entire
program is recorded, set the start
time about one minute before the
program actually starts.
7 <Set the End Time>
Use the TUNING/PRESET
[
]/[ ] buttons (TIMER
[ ]/[ ]) to set the end time.
Press the [MEMORY] button
(ENTER).
If you want to change any of the timer
settings, start again at the beginning of
this procedure.
8 <Switch to Standby>
Press the A-933’s [STANDBY/ON]
button to set the system to
Standby.
TUNING / PRESET
ENTER
MEMORY
<Remote controller>
➜
➜
TUNING / PRESET
ENTER
MEMORY
<Remote controller>
➜
➜
Numbers show which timers are on.
shows which timers are set to REC.
Timer indicators
STANDBY/ON
*En_T433_02.fm Page 25 Tuesday, February 15, 2005 3:09 PM