Optiview G0521 User Manual
Page 34
DVR Server Manual ver.5.05/rel.092507
30
【Alarm Action】
Select system alarm linkage mode when an alarm stops. ―Stop Immediately‖
means the system will stop the alarm immediately after the alarm driver stops an alarm.
―Do Not Stop‖ means the system will not stop the alarm after the alarm driver stops an alarm.
―Wait‖ means the system will stop the alarm at your setting time after the alarm driver stops an
alarm.
【Sensor input】Add sensor to selected group.
【Tie to cameras】Set cameras to be related to this sensor group. They will start recording and
connect remote network client automatically when there is an alarm. The cameras just include the
cameras of local board card; IP Cameras are not included. For IP Camera, you should set it remotely
in
【Tie to Relay Output】Add alarm devices (alarm out port) to this group such as siren, light. All
connecting devices will send alarm message when there is an alarm.
Schedule Setup (Example for below figure)
1. Check Alarm (Red): DVR System responds with sensor during this time. (00:30 to 12:00 from Sun.
to Sat.)
2. Do
Not Check (gray): DVR System doesn‘t respond with sensor in this time.
Note: If you set a camera in several groups, only the last setup is available. This means if one
camera is used and configured on more than one group, the last settings configured using that
camera will be used and the previous settings will be overwritten by the latest settings.