Oricom ECO3400 - Manual (Page 23)

The System
23
3. Enter the system PIN. Press to confirm. Use to make correction.
4. Enter the new system PIN. Press .
5. Enter the new system PIN again for verification.
6. Press . The new setting is saved.
RESETTING TO FACTORY DEFAULT SETTINGS
You can reset your phone settings to the factory default.
1. Press .
2. Select SYSTEM Æ RESET . Press .
3. Enter the system PIN. Press to confirm all settings have reset.
To find out what settings are being reset, see below.
Appendix
DEFAULT (PRE-PROGRAMMED) SETTINGS
General Setting
Language English Handset Name Reset
Auto Answer Off
Recall Duration Recall 1
Sounds Setting
Handset Melody Melody 3 Handset Ringer Volume Level 5
Base Melody Melody 1 Base Ringer Volume Level 3
Handset Key Tones On Receiver Volume Level 2
Handset Tones On
Call Log Setting
Incoming Call Log Unchanged Dialed Call Log Unchanged
Message Waiting Indicator Reset
System Setting
Base Selection Auto PIN Code 0000
Answering Machine Setting
Answer Machine Status On Ring Delay
Message Alert On Call Screening On
RA PIN Code 000 Answering Machine Language
Speaker’s Volume
NOTE:
Forgotten PIN. Write down your PIN and save it for future use. If you
have forgotten the PIN, call your manufacturer for assistance.
NOTE:
After reset, your handset’s power switches off. It will switch back on in a
few seconds after updating all the settings.