Olympus E-P3 - Manual (Page 112)

112 EN
Information
11
Drive
Drive mode Single-frame shooting/Sequential shooting/Self-timer
Sequential shooting 3 frames/sec.
Self-timer Operation time: 12 sec., 2 sec.
Flash
Guide number 10 (ISO200)
Flash control mode TTL-AUTO (TTL pre-fl ash mode)/MANUAL
Sync speed 1/180 s or slower
External connector
Multi-connector (USB connector, AV connector)/HDMI mini connector (Type C)/Accessory port
Power supply
Battery Li-ion Battery ×1
Dimensions/weight
Dimensions 122.0 mm (W) × 69.1 mm (H) × 34.3 mm (D) (4.8" Ч 2.7" Ч 1.6")
(excluding protrusions)
Weight Approx. 369 g (0.8 Ib.) (including battery and memory card)
Operating environment
Temperature 0 °C - 40 °C (32 °F - 104 °F) (operation)/ – 20 °C - 60 °C (– 4 °F - 140 °F)
(storage)
Humidity 30% - 90% (operation)/10% - 90% (storage)
HDMI, the HDMI logo and High-Defi nition
Multimedia Interface are trademarks or registered
trademarks of HDMI Licensing LLC.
Battery/charger
„ Lithium ion battery
MODEL NO. BLS-1 (PS-BLS1) BLS-5
Product type Rechargeable Lithium ion battery
Nominal voltage DC 7.2 V
Nominal capacity 1150 mAh
No. of charge and discharge times Approx. 500 times (varies with usage conditions)
Ambient temperature 0 °C - 40 °C (32 °F - 104 °F) (charging)
Dimensions Approx. 35.5 mm (W) × 12.8 mm (H) × 55 mm (D) (1.4" Ч 0.5" Ч 2.2")
Weight Approx. 46 g (0.1 Ib.) Approx. 44 g (0.1 Ib.)
„ Lithium ion charger
MODEL NO. BCS-1 (PS-BCS1) BCS-5
Rated input AC 100 V - 240 V (50/60 Hz)
Rated output DC 8.35 V, 400 mA
Charging time Approx. 3 hours 30 minutes (room temperature)
Ambient temperature 0 °C - 40 °C (32 °F - 104 °F) (operation)/
–20 °C - 60 °C (–4 °F - 140 °F) (storage)
Dimensions Approx. 62 mm (W) × 38 mm (H) × 83 mm (D) (2.4" Ч 1.5" Ч 3.3")
Weight (without AC cable) Approx. 72 g (0.2 Ib.) Approx. 70 g (0.2 Ib.)
The AC cable supplied with this device is for use only with this device and should not be
used with other devices. Do not use cables for other devices with this device.
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT ANY NOTICE OR
OBLIGATION ON THE PART OF THE MANUFACTURER.
•