Optimus 16-421 - Manual (Page 18)

18
4. Repeatedly press SEL or SEL to high-
light VIDEO ADJUST.
5. Press SET . A screen appears with the cur-
rent picture settings.
6. Repeatedly press SEL or SEL until
the setting you want to adjust is highlighted,
then press
SET . A screen showing the cur-
rently set adjustment for that setting
appears.
Note: To reset all settings to their factory
defaults, select
NORMAL .
7. Repeatedly press SEL or SEL to
adjust the picture as desired, then press
SET .
8. Repeat Steps 6 and 7 to adjust the other
setting(s) as necessary.
9. Press MENU three times to exit this mode.
Note: If you do not press any button within
5 minutes, the picture setting screen disap-
pears.
USING MUTE
To temporarily turn off the TV/VCR’s sound,
press
MUTE on the remote control. MUTE ap-
pears on the TV screen.
To restore the sound to the previous level, press
MUTE again. Or, to restore the sound and
change its level, press VOL or VOL .
USING LAST CHANNEL
RECALL
The TV/VCR’s last channel recall function lets
you quickly switch between two channels you
tuned.
Repeatedly press LCR (Last Channel Recall) on
the remote control to switch between the chan-
nel you are watching and the previous channel
you tuned.
VIEWING AN EXTERNAL
DEVICE
To view the signals from an external device con-
nected to the audio/video input jacks on the back
of the TV/VCR, do either of the following:
• Press MENU to display the main menu,
repeatedly press SEL or SEL to select
TV , then press SET . The SET UP TV
screen appears. Then repeatedly press
SEL or SEL to highlight INPUT
SELECT , press SET to select LINE ,
then press MENU twice. The menu disap-
pears.
• Select one channel higher than the highest
programmed channel or one channel lower
than the lowest programmed channel.
LINE appears on the TV screen.
16-421.fm Page 18 Tuesday, July 20, 1999 12:01 PM