Oregon Scientific Wireless Thermo Clock RMR602A - Manual (Page 10)

EN
9
TURN ATOMIC CLOCK ON/OFF
Perform this step if you cannot receive Atomic Clock
signals. Press and hold DOWN for 2 seconds. Then,
manually set the clock following the "Set Clock"
instructions (below).
SET CLOCK
You only need to do this if you have disabled the Atomic
Clock feature (for example, if you are too far from or
cannot receive a signal).
1. Press and hold MODE for 2 seconds. The Clock
Area will blink.
2. Select the hour offset (-9 to +9), hour display format
(12 or 24 hour), hour, minute, year, month, day, and
language. Press UP or DOWN to change the setting.
Press MODE to confirm.
The language options are (D) German,
(E) English, (F) French, (I) Italian, and (S) Spanish.
SWITCH CLOCK DISPLAY
Press MODE to toggle between Calendar and Clock
display with Hour Offset, Seconds, or Weekday.
The signal icon indicates that the Atomic Clock
feature is ON. No icon means that it is OFF.
ALARM
This product has 2 alarms: a Single Alarm and a Weekday
Alarm. The Single Alarm can be set to go off at a specific
time for a one-time event (for example, if you are napping
on Saturday). The Weekday Alarm will sound at the same
time Monday - Friday (but not on weekends).
VIEW ALARM SETTINGS
Press ((.)) to display the Alarm settings you wish to view:
Weekday or Single.
SET ALARM
1. Press ((.)) to display the type of Alarm you wish to
set: Weekday or Single.
2. Press and hold ((.)) again for 2 seconds. The Alarm
settings will blink.
3. Select the hour and minute. Press UP or DOWN to
change settings. Press ((.)) to confirm.
ACTIVATE ALARM
Press or to activate or deactivate the Alarm. ---
indicates that the alarm is deactivated.
STOP ALARM
To stop the alarm from ringing, press ((.)).
NOTE
RMR602A lab test R2 1/17/04, 4:49 PM 9