Oricom S6000 - Manual (Page 35)

• Press . Use to select DISPLAY.
• Press . Use to select CALL TIMER.
• Press . Use to choose ON or OFF.
• Press to confirm.
Backlit LCD / Backlit LCD & Keypad
The backlight will turn on when:
• a key is pressed
• there is an incoming call
• paging from the base.
The backlight will turn off:
• 10 seconds after a key is pressed
• 10 seconds after the internal or external call is answered if no key
is pressed afterwards
• 10 seconds after a call is ended
• when paging is stopped.
• when the incoming internal call ends without being answered
• when the incoming call expires at the handset.
You can also choose to turn off the backlight by
• Pressing . Use to select DISPLAY.
• Press . Use to select BACKLIT.
• Press . Use to select OFF.
• Press to turn off the backlight.
To turn on the backlit, user can
• Press . Use to select DISPLAY.
• Press . Use to select BACKLIT.
• Press . Use to select ON.
• Press to turn on the backlight.
Change the PIN Code for Base
PIN code for the base unit is required in order to
• Change Prefix settings,
• Change Call Barring settings,
• Register a handset,
• Deregister a handset,
• Reset the phone settings, and
• Change the current PIN.
The PIN code includes zero to eight digits.
To change the PIN code:
• Press . Use to select SYSTEM.
• Press . Use to select CHANGE PIN. Press .
• The display reads PIN?. Enter the correct PIN of the connected
base. Press .
• The display reads NEW PIN?. Enter the new PIN (maximum 8
digits).
• Press to confirm. The display will read REPEAT.
• Re-enter same PIN again.
• Press to confirm.
Note: If you changed the PIN CODE, you’ve to use the new PIN CODE
in all handsets.
35 of 42