One for All URC-9990 - Manual (Page 35)

8. If you want to test Home Theater, press down on ESC or MUTE for at 2 seconds to return to the
last-displayed Device Screen. Then tap on the THEATER Key to see the composite screen (see
example).
NOTE: Depending on the devices you program, the Home Theater composite screen on your
MOSAIC may look different than the one shown in the example above.
P
ROGRAMMING
T
HE
H
OME
T
HEATER
P
OWER
M
ACRO
1. If necessary, perform steps 1 through 3 of the previous section (Programming Home Theater
Devices on page 33) to view the Theater Setup Menu.
2. In the Program Power Macro sub-menu, tap on the NEW key. You will see the THEATER SETUP
Device Selection Strip.
NOTE: Tapping on the NEW key will also override any previously-programmed Power Macro.
3. Using a procedure similar to the one described in Adding A Macro (starting on page 12), tap on
successive devices and their functions to program the macro.
4. After you have programmed the macro, aim MOSAIC at your Home Theater system and tap on
the TEST key. If the devices respond incorrectly, tap on the CLEAR key and repeat steps
3 and 4.
1 2 3
4 5 6
7 8 9
0
TV/VCR PWR
CBL TV VCR
THEATER Setup
Tap on
Vid Out
Shuffle Track+ Track-
CBL TV VCR
V
C
R
C
D
THEATER Setup THEATER SETUP
Press OK to save.
Esc OK
CBL TV VCR
V
C
R
NEW
Video Playback VCR
Channel Source CBL
Audio Playback CD
Menu Source
PIP
Audio Source
Pro-Logic
THEATER SETUP
Configure the remote control
to match your Home Theater.
What device is used for:
Program Power Macro
Esc ?
Tap on
1 2 3
4 5 6
7 8 9
0
TV/VCR PWR
THEATER SETUP
Begin recording the
keystrokes.
Esc
CBL TV VCR
34 www.oneforall.com