Oricom P80 User Manual
Page 17
17
You cannot program the base ringer if the handset has lost link with the base.
UNAVAIL will be displayed. Re-establish the link and try again.
Recall duration
When you are talking on the phone, pressing will send a flash signal.
Recall settings are; Australia (Recall 1)100ms and New Zealand (Recall 2)
600ms. You should not need to change these settings.
Press
PROG
during standby and press
until you see flashing.
1. Press
OK
to select. The current duration is now displayed.
2. Press
1 or 2 directly or press
to select.
3. Press
OK
to confirm.
Register
Each handset can register to one base at a time only. The current base will
be deregistered when a new base is registered.
Each base can register up to
4
handsets.
1. Press
PROG
during standby and press or until you see icon
flashing.
2. Press
OK
to select.
3. Before you enter the PIN, press and hold
on the base for
2
seconds
until a registration tone is emitted. The base is now in the registration
mode. (If the base is full and cannot take on any more handset, it will
emit a reject tone instead. See the section of Deregister to delete a
currently registered handset.)
4. Enter the PIN of the base and press
OK
.
You will hear a confirmation tone if the registration is successful. The
handset label and the handset number will be displayed.
If the registration is not successful, you will see NOT REG on the handset.
Follow the procedure and try again.
Deregister
A handset can deregister another handset registered to the same base. It
cannot deregister itself.
1. Press
PROG
during standby follow by the 9 key.
2. Enter the handset number (i.e. HS#2) to delete. The LCD will display 9-2.
3. Press
OK
and then
4. Enter the PIN
5. Press
OK
to confirm.