Oregon Scientific Orgin Scientific In-Out Thermometer EMR898A - Manual (Page 8)

GB GB
REMOTE TEMPERATURE READINGS
The remote temperature readings are displayed on the top line of the
LCD screen display (
→ p.11,A.).
Kinetic Wave Display
The Kinetic Wave Display is only shown on the top line of the main
unit. It displays the current receiving signal status from the remote
unit to the main unit. The display is shown in three different forms:
TEMPERATURE RANGE
This product is designed to work under the widest temperature ranges
possible. However, if the temperature falls above or below the device s
operation range, the display will change to the following:
MAXIMUM / MINIMUM TEMPERATURES
Displaying Maximum / Minimum Temperatures
The maximum and minimum indoor and remote temperatures
recorded are automatically stored in memory. To display them, follow
the instructions below:
LCD Display Description Signal
Blinking signal
Radiating signal
No signal
The main unit is searching for
signals from the remote unit.
Temperature readings from
the remote unit are securely
registered.
No signals received from the
remote unit. Searching has
stopped.
LCD Display Description
When the LCD screen displays HHH , the
temperature is above the measuring range of the
remote or main unit (see Specifications
→ p.24 ).
When the screen displays LLL , the temperature
is below the measuring range of the remote or
main unit (see Specifications
→ p.24 ).
1. Current remote and indoor
temperatures displayed.
2. Maximum temperatures recorded
are shown for both remote and
indoor temperatures.
3. Minimum temperatures recorded
are shown for both displays.
shown for both remote and indoor
temperatures.
LCD Display Description
Soon after the batteries have been installed, the
main unit searches for signals from the remote unit.
This process takes about 4 minutes.
Upon successful reception, the remote unit
temperature is displayed on the top line of the
LCD (
→ p.11.A.).
If no signals are received from the remote unit, the
top temperature remains blank and the unit stops
searching. To force the main unit to search once
again, use a blunt stylus to press the RESET Hole
located at the back (
→ p.11,A.).
12 13
Press MEMORY
Press
MEMORY
Press MEMORY
EMR898_GB(02/05) 12/1/03, 10:36 AM Page 14-15 Adobe PageMaker 6.5C/PPC