Optoma Optoma TXR774 - Manual (Page 51)

English
51
Troubleshooting
If you experience a problem with your projector, please refer to the follow-
ing information. If a problem persists, please contact your local reseller or
service center.
Image Problems
No image appears on-screen

Ensure all the cables and power connections are correctly and
securely connected as described in the Installation section.

Ensure all the pins of connectors are not bent or broken.

Check if the projection lamp has been securely installed. Please
refer to the Replacing the lamp section.

Make sure you have removed the lens cap and the projector is
switched on.
Partial, scrolling or incorrectly displayed image

Press “Re-Sync” on the remote.

If you are using a PC:
For Windows 95, 98, 2000, XP:
1. Open the My Computer icon, the Control Panel folder, and
then double click on the Display icon.
2. Select the Settings tab.
3. Verify that your display resolution setting is lower than or
HTXDOWR8;*$ [ 
4. Click on the Advanced Properties button.
If the projector is still not projecting the whole image, you
will also need to change the monitor display you are using.
Refer to the following steps.
9HULI\WKHUHVROXWLRQVHWWLQJLVORZHUWKDQRUHTXDOWR8;*$
(1600 x 1200).
6. Select the Change button under the Monitor tab.
7. Click on Show all devices. Next, select Standard monitor
types under the SP box; choose the resolution mode you
need under the “Models” box.
8. Verify that the resolution setting of the monitor display is
ORZHUWKDQRUHTXDOWR8;*$ [ 
Appendices