Oki 58374501 - Manual (Page 8)

12. Secure the stacker with four screws.
13. Push the finisher against the printer until the
prongs on the printer brackets fit into the
holes in the finisher.
Note: If you need to, turn the levellers ( ! ) on
either side of the finisher to raise or
lower it so the holes and prongs align
properly. Make sure the finisher is level.
Step 5: Make Connections
1. Connect the finisher’s cable to the inverter
( ! ). Use the cable supplied to connect the
inverter to the printer ( " ).
2. Plug the power cord supplied into the
inverter, then connect it to a suitable
grounded outlet.
3. Reconnect the printer’s interface cable.
4. Plug in the printer’s power cord and turn on
the printer.
Note: When the printer is turned on, power
is supplied to both the printer and the
finisher.
58374501