Oricom P900 - Manual (Page 27)

27
To review the current ring delay setting,
1. Press during standby. The 7-segment LCD displays the
current setting such as
r2
for 2 rings.
To change the ring delay setting,
1. Press for 2 seconds. The 7-segment LCD displays the current
setting such as
r2
for 2 rings.
2. Use or to adjust the number of rings.
3. Press again to confirm. The 7-segment LCD displays the new
setting.
Security PIN
A three-digit PIN is required for remote access. The factory preset code
is “000”. You can change it to a unique code of your own. This PIN code
can be up to 3 digits long.
To review the Security PIN,
1. Press during standby. The 7-segment LCD displays the current
PIN digit by digit.
To change the Security PIN,
1. Press for 2 seconds during standby.
2. Use or to change the first digit.
3. Press to confirm the first digit.
4. Use or to change the second digit.
5. Press to confirm the second digit
6. Use or to change the third digit.
7. Press to confirm the third digit. The 7-segment LCD displays the
new PIN digit by digit.
NOTE: The security PIN is different from the 4-digit PIN which is used for
registering/de-registering your handset(s).
RING
RING
VOL- VOL+
RING
PIN
PIN
VOL- VOL+
PIN
VOL- VOL+
PIN
VOL- VOL+
PIN