Oki ML520 - Manual (Page 154)

Paper Out Override No Yes
Print Registration O 0.05 mm Left 0.10 mm Left 0.15 mm Left 0.20
mm Left 0.25 mm Left 0.25 mm Right 0.20 mm
Right 0.15 mm Right 0.10 mm Right 0.05 mm
Right
Operator Panel Function Full Operation Limited Operation
Reset Inhibit No Yes
Print Suppress Effective Yes No
Auto LF No Yes
Auto CR * * * * No Yes
CSF Bin Select * * * Bin 1 Bin 2
Print DEL Code * * No Yes
SI Select Pitch (10 CPI) * *
* * 17.1 15 cpi
SI Select Pitch (12 CPI) * *
* * 20 12 cpi
Time Out Print Valid Invalid
Auto Select No Yes
Printhead Gap Adjust 0 - 1 + 1
* Model 521 only
* * Appears only when Microline emulation is selected
* * * Appears only when optional Cut Sheet Feeder is installed
* * * * Appears only when IBM Proprinter emulation is selected
* * * * * Appears only when Epson LQ emulation is selected
* * * * * * Appears only when optional Serial Interface is installed
* * * * * * * Appears only when optional Roll Paper Stand is installed
Factory default settings are printed in Bold Italic.