Oricom M5000 - Manual (Page 4)

ABOUT YOUR PHONE
M5000 User guide.doc Page 7 of 20
LED Indicator lights
Icons on your handset’s display
The top line shows the handset number. When you make a call it shows the dialled number, call duration
and other icons as shown below.
Memory / store a number Caller display
Battery level (3 bars fully charged) Battery low
Ringer on Ringer off
Speakerphone on Antenna in range/out of range
Key pad locked Intercom call to another handset
Connected to telephone line.
Flashes – when incoming call or paged
X appears – microphone muted Use arrows to scroll left or right
Memory FULL
indicator
1.
RED - FULL
2. NO COLOUR –
Messages can
be added
Answering machine ON/OFF
indicator
1. NO COLOUR - OFF
2. STEADY - ON
3. FLASHES – Check messages
Mains power indicator
1.
GREEN – Power ON
2. NO COLOUR –
Power OFF
Base unit’s speaker phone
indicator
1. RED - activated
2. NO COLOUR – Not
activated
Handset Locator button
Hands-free
speakerphone button
Call duration Handset Number
ABOUT YOUR PHONE
M5000 User guide.doc Page 8 of 20
5 Making Calls
Make a handset call
1. Key number into telephone.
2. If necessary, press
MUTE/DEL to clear single digit or Press & Hold MUTE/DEL to clear all digits
3. Press PHONE button to dial.
4. if necessary, press LAST NUMBER REDIAL button.
Answer a call
When the handset rings:
1. Press
PHONE or SPEAKERPHONE button.
End a call
1. Press PHONE or SPEAKERPHONE button. The symbol disappears from the display.
Last Number Redial (on handset)
To call anyone of the last 3 numbers dialed:
1. Press
LAST NUMBER REDIAL/P button.
2. If necessary, press LAST NUMBER REDIAL/P button again, until you select your number.
3. Press PHONE button to dial.
Note: If using the BASE UNIT to call:
1. Press
SPEAKERPHONE button to get a dial tone.
2. Key number into telephone.
3. If necessary, press
MUTE/DEL to clear single digit or Press & Hold MUTE/DEL to clear all digits
4. Press PHONE button to dial.
5. If necessary, press LAST NUMBER REDIAL button.
Note: If using the BASE UNIT to call or use last number redial:
1. Press SPEAKERPHONE button to get a dial tone.
2. Press LAST NUMBER REDIAL/P button.
3. If necessary, press LAST NUMBER REDIAL/P button again, until you select your number.
4. Press SPEAKERPHONE button to dial.
Note: OUT-OF- RANGE warning
You may be out-of-range with the BASE UNIT if you hear a warning tone or the sound becomes distorted.
Either
1.
Move handset closer within 20 seconds until the tone stops. Otherwise, your call may be cut off.
2. Reposition & reconnect BASE UNIT to a phone connection closer to where the handset will be used
(an extension lead(s) for power & telephone line may be useful where necessary).
Note: Call timer - The call timer shows the duration of your current call on display.