Onkyo TX-SR501 - Manual (Page 27)

27
Configuring Speaker Set A—Continued
With this function you can adjust the volume of each individ-
ual speaker so that you can hear all speakers equally at the
listening position.
Note:
You cannot use this function while the TX-SR501/
TX-SR501E is muted (see page 33).
Note:
If no adjustments are made for two minutes, this function is
cancelled automatically and the previous display reappears.
Adjusting Individual Speaker Volume
1 Press the remote controller’s
[TEST] button, and turn up the vol-
ume so that you can hear the test
tone sufficiently.
While each speaker outputs the test tone
(pink noise), its name appears on the dis-
play, as shown.
2 Use the remote controller’s
[CH SEL] button to select each
speaker, and use the LEVEL [ ] [ ]
buttons to adjust the volume.
Speakers are selected in the following
order: Left
→
Center
→
Right
→
Surr
Right
→
Surr Back
→
Surr Left
→
Sub-
woofer.
You can adjust the volume of each
speaker from –12 dB to +12 dB.
Notes:
• Only speakers that are included in the
current configuration output the test
tone. See “Specifying the Number of
Speakers” on page 25.
• The subwoofer will not output the test
tone if it’s off. See “Setting the Sub-
woofer Mode” on page 25.
• If you don’t press any buttons for two
seconds, the next speaker is selected
automatically.
CH +
CABLE/SAT
CD/DVD
LEVEL /
CH SEL
TEST
VOLUME /
3 When you’ve adjusted each
speaker, press the remote control-
ler’s [TEST] button.
The test tone stops and the previous dis-
play reappears.