Onkyo TX-SR501 - Manual (Page 5)

5
Before Using the TX-SR501/TX-SR501E
The Worldwide model has a voltage selector for compatibil-
ity with power systems around the world. Before you plug in
this model, make sure that the voltage selector is set to the
correct voltage for your area. If it isn’t, use a small screw-
driver to set it as appropriate. For example, if the voltage in
your area is 120 volts (V), set the selector to “120V.” And if
it’s between 220 and 230 volts (V), set it to “220–230V.”
Notes:
• The supplied batteries should last for about six months,
although this will vary with usage.
• If the remote controller doesn’t work reliably, try replacing
both batteries.
• Don’t mix new and old batteries, or different types of bat-
teries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage and
corrosion.
• Flat batteries should be removed as soon as possible to pre-
vent possible leakage and corrosion.
To use the remote controller, point it at the TX-SR501/
TX-SR501E’s remote control sensor, as shown below. The
TX-SR501/TX-SR501E’s STANDBY indicator flashes
while a signal is being received from the remote controller.
Notes:
• The remote controller may not work reliably if the
TX-SR501/TX-SR501E is subjected to bright light, such
as direct sunlight or inverter-type fluorescent lights. Keep
this in mind when installing the TX-SR501/TX-SR501E.
• If another remote controller of the same type is used in the
same room, or the TX-SR501/TX-SR501E is installed
close to equipment that uses infrared rays, the remote con-
troller may not work reliably.
• Don’t put anything, such as a book, on the remote control-
ler, because the buttons may be pressed inadvertently,
thereby draining the batteries.
• The remote controller may not work reliably if the
TX-SR501/TX-SR501E is installed in a rack behind col-
ored glass doors. Keep this in mind when installing the
TX-SR501/TX-SR501E.
• The remote controller will not work if there’s an obstacle
between it and the TX-SR501/TX-SR501E’s remote con-
trol sensor.
Setting the Voltage Selector
(Worldwide model only)
Installing the Batteries
1 Open the battery compartment, as shown.
2 Insert the two supplied batteries (AA/R6) in
accordance with the polarity diagram inside
the battery compartment.
3 Close the battery compartment.
L
R
R
L
R
L
ANTENNA FM 75 AM
FRONT SPEAKERS A FRONT SPEAKERS B SURROUND SPEAKERS CENTER SPEAKER
R
L
SURROUND BACK SPEAKER
REMOTE
CONTROL IN IN IN
OPTICAL COAXIAL 1 2
IN IN IN IN FRONT SURR CENTER
SUB WOOFER
OUT
OUT OUT
DIGITAL INPUT
VIDEO 2 VIDEO 1 DVD MONITOR OUT
VIDEO
S VIDEO
DVD TAPE CD
L
R
VIDEO 2 VIDEO 1
SUBWOOFER PRE OUT
VIDEO 1 / 2 / 3 IN DVD IN COMPONENT VIDEO
Y
P B
P R
OUT
L
R
SWITCHED
100W MAX.
AC OUTLET
120 V
VOLTAGE SELECTOR
220-230 V
120 V
VOLTAGE
SELECTOR
220-230 V
Using the Remote Controller
30˚
30˚
TX-SR501/TX-SR501E
Remote control sensor
Standby indicator
Appr
ox
. 16 ft.
(5 m)