One for All URC-7040 - Manual (Page 10)

10
W W W.ONEFORALL.COM
Colour and Brightness
Depending on the functions of your original remote control, the ONE FOR
ALL 4 may operate the colour and brightness settings of your television.
Colour (+) = Press and release MAGIC then hold Volume (+)
Colour (-) = Press and release MAGIC then hold Volume (-)
Brightness (+) = Press and release MAGIC then hold Channel (+)
Brightness (-) = Press and release MAGIC then hold Channel (-)
Volume Punch Through
You may be able to use some functions of your Television, Video recorder,
DVD player, Satellite receiver or Cable converter at the same time. For
example: if you are watching a programme on your video recorder, you
can adjust the volume (a TV function) without pressing the TV mode key
on your ONE FOR ALL 4. The table below lists some of the possibilities.
Last Device Mode Key Pressed: You Can Control:
VCR TV volume up and down, mute
SAT TV volume up and down, mute
DVD TV volume up and down, mute
To punch through to TV volume while in the VCR, DVD or SAT mode:
1
Press and hold MAGIC until the red light blinks twice.
2 Press 9 9 3.
3 Then press the TV key and the red light will blink twice.
To cancel the "Volume Punch Through":
1
Press and hold MAGIC until the red light blinks twice.
2 Press 9 9 3.
3 Press the Volume (+) key and the red light will blink four times.
Auto Scan
Your ONE FOR ALL 4 comes with a special Scan function which lets you scan
through every channel available on your television.
To scan the channels on your TV:
1 Aim the ONE FOR ALL 4 at your TV. Press the TV key. Press and relea-
se MAGIC then press the MUTE key.
The ONE FOR ALL 4 will send the command to advance through all
the channels available on your television stopping at each channel
for about three seconds. Remember, you must aim the ONE FOR ALL
4 at your television the entire time you are using scan.
2 When you find a channel you would like to watch, simply press any
key to stop the scan.
Advanced Features
Important note: Auto Scan may not work with devices that do not have
Channel +/- keys on the original remote control.
Important note: You have 5 seconds to press the Volume or Channel keys
for the colour or brightness adjustments after pressing MAGIC.