Onkyo TX-NR1008 - Manual (Page 31)

31
En
Changing the Speaker Settings Manually
You can manually make changes to the settings found dur-
ing Audyssey MultEQ
® Room Correction and Speaker
Setup.
See also:
• “Speaker Configuration” (
➔
47)
• “Speaker Distance” (
➔
48)
• “Level Calibration” ( ➔ 48)
• “Equalizer Settings” (
➔ 49)
Note
• Please note that THX recommends any THX main speakers be
set to “80Hz(THX)”. If you set up your speakers using
Audyssey MultEQ Room Correction and Speaker Setup,
please make sure manually that any THX speakers are set to
80 Hz (THX) crossover (
➔ 47).
• Sometimes due to the electrical complexities of subwoofers and
the interaction with the room, THX recommends setting the level
and the distance of the subwoofer manually.
• Sometimes due to interaction with the room, you may notice
irregular results when setting the level and/or distance of the
main speakers. If this happens, THX recommends setting them
manually.
Using a Powered Subwoofer
If you’re using a powered subwoofer and it outputs very
low-frequency sound at a low volume level, it may not be
detected by Audyssey MultEQ Room Correction and
Speaker Setup.
If the “Subwoofer” appears on the “Review Speaker
Configuration” screen as “No”, increase the subwoofer’s
volume to the half-way point, set it to its highest crossover
frequency, and then try running Audyssey MultEQ Room
Correction and Speaker Setup again. Note that if the vol-
ume is set too high and the sound distorts, detection issues
may occur, so use an appropriate volume level. If the sub-
woofer has a low-pass filter switch, set it to Off or Direct.
Refer to your subwoofer’s instruction manual for details.