Ovation Software Label Printer - Manual (Page 20)

Getting Started
12 Ovation

2
The second label printed is the test pattern label. This label is used to
determine whether the printhead is in need of replacement. 'Good' and
'Bad' Test Pattern labels are shown below:
Good Test Label: Indicates
that the printhead is operating
normally.
Bad Test Label: Streaks in
test label indicate a dirty or
faulty printhead.
(See Chapter 3 for cleaning
and replacement.)
Figure 1-13 Printhead Test Label
1.11 Setting the Printer to the Factory Defaults
With the printer off, press and hold the feed button while turning the
printer on. Continue to hold the feed button for 60 seconds and then
release. The printer will now be set to the 'Factory Defaults', which
are shown in Table 1-1.
Function Value
Baud Rate 9600
Word Length 8 bits
Print Method direct thermal
Alternate Character Set standard
Cutter disabled
Paper Type gap
Table 1-1 Factory Default Settings