Oki C 9400 - Manual (Page 397)

1. On the printer control panel, press MENU repeatedly until INFORMATION MENU
appears on the display.
2. Press SELECT.
PRINT MENU M
appears on the display.
3. Press SELECT.
The MenuMap prints.
4. Check the MenuMap printout:
• At the top of the printout you should see a line HDD:5.00 GB
• In the right column you should see a new menu section DISK MAINTENANCE
5. If you do not see these, remove the control board, lift the hard drive handle and check to
be sure that the hard drive is firmly inserted in the connector. Then reinstall the control
board and print the Menu Map again.
Step 5: Activate the Hard Disk in the Printer Driver
Windows PCL Driver
1. Click Start
→ Settings → Printers.
2. Right click the OKI C9200 or C9400 PCL driver icon, then click Printing Preferences,
Properties or Document Defaults, depending on the Windows operating system.
3. In the Paper tab, click Device options.
4. Click Printer hard disk to select it, then click OK.
5. Click OK, then close the Printers dialog box.
Windows PostScript Driver
1. Click Start
→ Settings → Printers.
2. Right click the OKI C9200 or C9400 PostScript driver icon, then click Properties.
3. Activate the hard disk drive:
Windows 2000 and NT 4.0:
a. Click the Device Settings tab.
b. Scroll down to Installable Options and click Hard Disk.
c. Under Change 'Hard Disk' Setting, click Installed.
Windows Me, 98 and 95:
a. Click the Device Options tab.
b. Click Hard Disk.
c. Under Change setting for: Hard Disk, click Installed.
4. Click OK, then close the Printers dialog box.
Duplex Unit, OKI P/N 70037101
396