Onkyo DV-S535 - Manual (Page 10)

10
FIRST SETUP
TV Shape 4:3LB
Thank you for your purchase of Our DVD-Video Player.
Please make a selection
for On-Screen Language and your TV shape and
press ENTER button on your remote control.
On-Screen Language ENG
STANDBY/ON
STANDBY
POWER PAUSE DIMMER
OFF ON
OPEN/CLOSE CURSOR
RETURN SETUP MENU
STOP PLAY
ENTER
TOP MENU MENU
RETURN SETUP
SUBTITLE
DIMMER DISPLAY
SUBTITLE
ON/OFF AUDIO ANGLE
OPEN/
CLOSE
POWER
SEARCH
FR FF UP DOWN
STOP PLAY PAUSE/STEP
ZOOM RANDOM CLEAR MEMORY
A-B REPEAT SLOW
3 2 1
6 5 4
9 8 7 0
+10
ENTER
REMOTE CONTROLLER RC-419DV
CURSOR
RETURN SETUP MENU
ENTER
STANDBY/ON
STANDBY
POWER
OFF ON
ACOUSTIC CONTROL
Before connecting
• Make sure that all the connections on pages 8
and 9 are complete (the connection to a TV is
required).
• Turning on the DVD Player may cause a
momentary power surge, which might interfere
with other electrical equipment such as
computers. To prevent the interference, use a
wall outlet on a different circuit.
2
Press the POWER switch to
switch on the main power.
The DVD Player enters standby mode.
The STANDBY indicator lights up.
Notes
• The buttons on the remote controller don’t operate if the
POWER switch is set to OFF.
• To switch off the main power, press the POWER switch again.
3
Press STANDBY/ON on the DVD Player
or POWER on the remote controller.
The DVD Player turns on. The STANDBY indicator goes off.
The first time you turn on the DVD Player, the First Setup screen
appears.
With the First Setup screen, select the On-Screen Language and TV Shape
according to the aspect ratio of the TV screen (see pages 30 and 31)
following the steps below.
1 Press / to select “On-Screen Language,” then press ENTER (the
center of the cursor).
2 Select a language with / , then press ENTER.
3 Press to select “TV Shape,” then press ENTER.
4 Press / to select the aspect ratio of the TV screen, then press
ENTER.
5 Finally press SETUP.
All your selections are set and the First Setup screen disappears.
Notes
• To turn off the DVD Player, press STANDBY/ON on the DVD Player, or POWER on
the remote controller. The DVD Player enters standby mode. Be sure to set the
volume to minimum before turning off the DVD Player for the next use to avoid
sudden loud sound reproduction.
• You can change the above settings later with “Customizing the Function Settings” on
page 28.
1
Connect the power
cord to a wall outlet.
To a wall outlet
STANDBY indicator
(lights up when in
standby mode)
The remote controller can also
be used to operate step 3.
Connecting the Power/
Turning on the DVD Player