Opticon OPL972X - Manual (Page 10)

10 - OPTICON OPL972X/CRD972X
2.1 FIX HAND STRAP
Instructions
1. Fix the small thin cord of the strap around the
pillar of the bar code data collector. (ref. 1)
2. Insert the handle cord of the strap into the thin
loop in order to fix the hand strap. (ref. 2)
TO AVOID DROP HOLD THE HAND STRAP
AROUND THE WRIST WHEN CARRYING THE
BAR CODE DATA COLLECTOR. (REF. 3)
DO NOT SWING THE BAR CODE DATA
COLLECTOR AROUND. (REF. 4)
2.2 BATTERY INSTRUCTIONS
FOLLOW THE INSTRUCTIONS FOR
INSTALLING, CHARGING AND REMOVING THE
BATTERIES VERY STRICTLY.
WRONG USE OF BATTERIES MIGHT CAUSE
SERIOUS DAMAGE TO THE BAR CODE DATA
COLLECTOR OR TO THE CRADLE.
THE PRODUCTS ARE NOT WARRANTED FOR
DAMAGE, DEFECTS, MALFUNCTION OR LOSS
OF DATA, RESULTING FROM INCORRECT USE
OF BATTERIES.
Never remove the battery while the bar code
data collector is turned on.
Doing so can cause data in the bar code data
collector to be deleted. If you have data stored,
make sure the data is transmitted to the host
system.
Use proper battery
Only use the Opticon rechargeable battery as
specified from Opticon.
Insert the battery correctly.
The bar code data collector may be damaged by
wrong insertion. Handle properly and do not force.
Use the cradle to charge battery
The battery of Opticon can only be charged inside
the bar code data collector.
2.2.1 HOW TO CHARGE THE BATTERY
If the bar code data collector with the battery is
placed in the cradle, the voltage and the required
charging time will be automatically determined and
the cradle will charge for a maximum of 8 hours.
The charging procedure is fully automated.
1
2
3 4