Oregon Scientific RAR186 - Manual (Page 8)

EN
8
CHANNEL for 2 seconds.
If the sensor is still not found, check the
batteries, obstructions, and remote unit location.
Signals from household devices such as
doorbells, electronic garage doors, and home security
systems may cause temporary reception failure. This is
normal and does not affect general product performance.
The reception will resume once the interference ends.
CLOCK
This product shows the current time, time zone, and day
--- shows in Temp
Areas
ICON DESCRIPTION
Main unit is searching for
sensors.
At least 1 channel has
been found.
Channel 1 is selected (number
will change depending on the
sensor you select)
The selected sensor cannot
be found. Search for the
sensor or check batteries.
of week in English, German, Italian, or French.
Manually set the clock following the "Set Clock"
instructions (below).
SET CLOCK
1. Press and hold MODE for 2 seconds. The Clock
Area will blink.
2. Select the hour, minute, date, month, language, day
and time zone offset (-12 to +12). Press UP or
DOWN to change the setting. Press MODE to
confirm.
The Language settings are (E) English, (D)
German, (F) French, and (I) Italian
SWITCH CLOCK & CALENDAR DISPLAY
Press MODE to toggle between Clock with Seconds,
Clock with Weekday, Clock with Weekday and Zone
Time, and Zone Time with Weekday and Zone Calendar.
ALARM
This product is equipped with a 2-minute crescendo alarm.
NOTE
NOTE
NOTE
The reception icon shown in the Temperature Area
shows the status.
SEARCH FOR SENSOR
To search for a sensor, press and hold MEM and