One for All (URC-8910) - Manual (Page 5)

SETTING THE CLOCK
1. On the URC-8910 remote control, press and hold
SET until you see the display change from the default
device and time to [CODE SET].
NOTE: Default values for device, its code, and time are
shown above.Your remote control settings may be different.
NOTE: If you wish to exit the programming mode at any
time, press EXIT once. You will see an [EXIT] message as the
remote control returns to normal operation.
NOTE: If you see an [INVALID] message, you have inadver-
tently pressed an incorrect key. Simply note your error and
continue programming.
2. Press the ▲ key five times until you see the display
change to [CLOCK SET].
(x 5)
NOTE: If you go past [CLOCK SET], press the ▼ key one or
more times to return to it.
3. Press SELECT once to begin programming.You will
see the display change to the current time.
4. Press the ▲ key one or more times until you see the
desired hour (a.m. or p.m.).
5. Press the ▼ key one or more times until you see the
desired minute.
6. Once the time is correctly set, press SELECT once to
accept the values. The display will confirm your
entry with [SUCCESS] and then [EXIT SETUP].
The URC-8910 remote control will return to
normal operation.
SELECT
SELECT
5