Oregon Scientific RMR612HGA - Manual (Page 10)

EN
9
ALARM
This product is equipped with a 2-minute crescendo alarm
and 8-minute snooze.
VIEW ALARM SETTINGS
Press . The Alarm Time and On/Off status will show in
the Clock Area.
SET ALARM
1. Press .
2. Press and hold again for 2 seconds. The Alarm
settings will blink.
3. Select the hour and minute. Press UP or DOWN to
change settings. Press
to confirm.
ACTIVATE ALARM
Press to activate or deactivate the Alarm. shows in
the Clock Area when the Alarm is activated.
SNOOZE ALARM
Press SNOOZE to silence the Alarm for 8 minutes.
If no button is pressed, the Alarm will automatically
silence after 2 minutes. It will then sound again after
8 minutes.
TEMPERATURE AND HUMIDITY
This product can display the following temperature and
humidity information:
• Current, minimum and maximum readings
• Trend line
Data is collected by the remote sensors and displayed
every 40 seconds.
SELECT TEMPERATURE UNIT
Slide the ° C / ° F switch into the desired location. The
switch is located in the battery compartment. The setting
for the main unit overrides the remote sensor setting.
SELECT SENSOR CHANNEL
Press CHANNEL to switch between sensors 1 - 3.
The house icon shows the selected sensor.
Indoor
Display
Display
Remote
Display
Channel 1
Kinetic-
wave
Icon
Remote
Display
Channel 2
Remote
Display
Channel 3
RMR612HGA lab test R2 1/17/04, 4:58 PM 9