Sylvania SRTD420 - Manual (Page 30)

– 30 – EN
0C28
If the TV/DVD does not perform properly when operated as instructed in this Owner’s Manual, check the
TV/DVD, consulting the following checklist.
TROUBLESHOOTING GUIDE
Problem Corrective Action
No Picture or Sound
•
Try a new channel, if OK, then possible station trouble.
•
Make sure the power is turned on.
•
Press SELECT on the remote control to select TV mode. Then try
other TV feature.
•
Is antenna or cable connected to terminal on the back of the set?
•
If outside antenna is being used, check for broken wire.
Bars On Screen
•
If outside antenna is being used, check for broken wire.
•
Check for local interference
•
Check incoming CATV cable for loose or bad connections.
Picture Distorted or Blurred
•
Try a new channel, if OK, then possible station trouble.
•
If outside antenna is being used, check for broken wire.
•
Check incoming CATV cable for loose or bad connections.
Picture Rolls Vertically
•
Try a new channel, if OK, then possible station trouble.
Lines or Streaks in Picture
•
If outside antenna is being used, check for broken wire.
•
Check for local interference.
•
Check incoming CATV cable for loose or bad connections.
No Color
•
Try a new channel, if OK, then possible station trouble.
•
Is antenna or cable connected to terminal on the back of the set?
•
If outside antenna is being used, check for broken wire.
•
Adjust COLOR control.
•
Check incoming CATV cable for loose or bad connections.
Poor Reception on Some Channels
•
Try a new channel, if OK, then possible station trouble.
Ghosts in Picture
•
Is antenna or cable connected to terminal on the back of the set?
•
If outside antenna is being used, check for broken wire.
•
Check for local interference.
•
Check incoming CATV cable for loose or bad connections.
Weak Picture
•
Try a new channel, if OK, then possible station trouble.
•
Is antenna or cable connected to terminal on the back of the set?
•
If outside antenna is being used, check for broken wire.
•
Adjust CONTRAST & BRIGHT control.
•
Check incoming CATV cable for loose or bad connections.
Sound OK, Picture Poor
•
Try a new channel, if OK, then possible station trouble.
•
Is antenna or cable connected to terminal on the back of the set?
•
If outside antenna is being used, check for broken wire.
•
Check for local interference.
•
Adjust CONTRAST & BRIGHT control.
Picture OK, Sound Poor
•
Try a new channel, if OK, then possible station trouble.
•
Check for local interference.
Different color marks on screen
•
Magnetism from nearby unsealeded speakers or appliances might
affect the color of the TV picture. Move the TV/DVD away from the
speakers or appliances. The TV/DVD can repair itself automatically
by unplugging the TV/DVD power cord, and then plug it in again 30
minutes or so later.
Problem Corrective Action
No power • Make sure the power plug is connected to an AC outlet.
• Make sure the power is turned on.
The TV/DVD does not respond to • Check if the power plug is connected to an AC outlet.
the remote control. • Check the batteries in the remote control.
• Aim the remote control directly at the remote sensor. If necessary,
remove all the obstacles between the sensor and the remote.
• You have to be within 23 feet of the TV/DVD.
• Check if the correct mode is selected. If not switch the mode by
pressing SELECT on the remote control,whichever you need.
TV Mode
T9005UF(EN).QX3 04.4.12 10:06 AM Page 30