Quatech QSC-100 - Manual (Page 8)

2 Hardware Configuration
The QSC-100 is automatically configured at boot time by the computer's BIOS or
operating system. There are no required switches or jumpers to set for installation.
This chapter lists a number of optional jumper settings that control various
hardware features. Jumpers J3-J6 are grouped together at the end of the board opposite
the D-37 connector. Any changes from the factory default should be made before
installing the QSC-100 in the computer.
2.1 Factory Default Configuration
Figure 2 shows the jumper configuration as shipped from the factory, with two
spare jumpers applied in neutral positions. Remove one or both and apply as shown
in following sections to set optional features.
SPAD
X2
X4
X8
J3
J4
J5
J6
Figure 2 --- Factory default jumper configuration
2.2 Enable Scratchpad Register (SPAD, J6)
In the default configuration, an Interrupt Status Register and an Options Register
(see page 0) replace the scratchpad (base address + 7) of each UART. If the SPAD
jumper is applied as in Figure 3, the UART scratchpad registers are enabled, and the
Interrupt Status Register and the Options Register are not available.
SPAD
X2
X4
X8 J3
J4
J5
J6
Figure 3 --- Enable scratchpad registers
Quatech QSC-100 User's Manual 6