QSC Audio WL2102 - Manual (Page 5)

EN
5
NL8FC pin designations- Plug
viewed from the wiring side.
Input Connections
The input connectors are a pair of Neutrik NL8's wired in parallel. Connections for biamp and tri-
amp vary, see Table 1. The pin designations for the NL8FC cable connector is shown for reference,
bottom right.
Note! In three way mode, the Low Frequency Select switch position determines the
input connector wiring! Unexpected results may occur if switch positions and wir-
ing are not strictly controlled.
The WideLine loudspeaker is not equipped with a crossover network. All signal
processing must be done before connecting audio power to the loudspeaker. Do
not connect full-range audio to the high-frequency transducer or damage may
result!
Neutrik NL8FC Cable Connector Pinout
Below is a diagram showing the pin designation inside the Neutrik NL8FC connector. This informa-
tion is for reference only. Diagram is of the connector as viewed from the wire-insertion end.
Table 1: Input Connector Wiring, Two way and Three Way Modes
Pin
Two Way
Internal Shading
Network Inserted in
Signal Path
Three Way
Use External
Processing for
Shading, LF Select
Switch Position A
Three Way
Use External
Processing for
Shading, LF Select
Switch Position B
1+ LF + LF A + LF B +
1- LF - LF A - LF B -
2+ Not Used LF B + LF A +
2- Not Used LF B - LF A -
3+ Not used Not used Not used
3- Not used Not used Not used
4+ HF + HF + HF +
4- HF- HF- HF -