Antenna connection, Optional equipment connections, To audio amplifier – QUASAR SP3234 User Manual
Page 5: Nstalllation antenna connection, Procedure, Audio adjustments
5
I
NSTALLLATION
Antenna Connection
•
For proper reception of VHF/UHF channels, an external
antenna is required. For best reception an outdoor antenna
is recommended.
•
Antenna Mode must be set to TV.
Note:
Cable Mode is preset at the factory.
Antenna users must change to TV Mode in
the SETUP Menu.
Optional Equipment Connections
VCRs, video disc players, video game equipment, and DSS equipment can
also be connected to the video input connection. (See your
equipment manual).
Note:
If S-VIDEO and VIDEO input are used at the same time, two
images will appear on the TV screen.
Procedure
1.
Connect equipment as shown to rear Audio/Video input jacks.
2.
Select the Video mode by pressing TV/VIDEO button.
3.
Operate optional equipment as instructed in equipment manual.
TO AUDIO AMPlifier
Connect to an external audio amplifier input for listening to a stereo system.
Note:
TO AUDIO AMP terminals cannot be connected directly to
external speakers.
Audio Adjustments
1.
Select TV SPEAKERS ON located in the AUDIO menu.
2.
Set amplifier volume to minimum.
3.
Adjust TV volume to desired level.
4.
Adjust amplifier volume to match the TV.
5.
Select TV Speakers OFF&VAO from AUDIO menu.
6.
Volume and mute are now controlled from the TV.
Note:
In OFF&FAO the volume is controlled by the external amplifier.
Incoming Cable from
Home Antenna
L
R
AUDIO OUT
VIDEO OUT
VCR
ANT INPUT
CABLES NOT SUPPLIED
OUTPUT
TERMINALS ON BACK OF TV
ANT
L
R
TO AUDIO
AMP
VIDEO
AUDIO
2
INPUT
1
S-VIDEO
S-VIDEO OUT
0374E-1prod.fm Page 5 Monday, February 26, 2001 4:40 PM