Quantum DLTSageTM Tape Security PX500 Series - Manual (Page 5)

PX500 Series DLTSage™ Tape Security Quick Start Guide
5
Figure 8 Create Secure Key
Name/Secure Key Pair
To create a secure key name/secure key pair:
1 Enter the Secure Key Name.
2 Enter a securekey in the protected Secure Key field.
3 Enter the same Secure Key in the Verify Secure Key
field.
4 Click New to create the Secure Key name/key pair.
Delete Secure Key Name 0
Refer to figure 9 for information on Delete Secure Key
Name .
Figure 9 Delete Secure Key Name
The Secure Key Names maintained on the library are
displayed in one of three lists:
N OTE : The Secure Key name must be less than 12
characters, may include spaces, but cannot
contain the following characters: ( ) = ;
N OTE : The Secure Key must be at least 8 characters
and no more than 32 characters.
•
Unused Secure Keys
- keys not associated with any
cartridges or tape drives currently in the system.
•
Inactive Secure Keys
- keys associated with cartridges
in the library, or currently assigned to the library, but
not assigned to any tape drives.
•
Active Secure Keys
- keys currently assigned to a tape
drive.
To delete a Secure Key Name/Secure Key pair from the
library:
1 Select the desired Secure Key Names from the
available lists.
2 Click Delete.
A confirmation message will be displayed, click Yes to
continue.
Any tape drives that have been Secure Key enabled will
remain enabled, but the Secure Key will not be used to
read or write cartridges.
Backup Secure Key File 0
Refer to figure 10 for information on Backup Secure Key
File .
Figure 10 Backup Secure Key File
The list of Secure Key Name/Secure Key Pairs maintained
on the library should be backed up to a local device
whenever a change is made to the security keys.
1 Click Save As...
2 From the browser's Save window, select a path and
name the file.
3 Click OK.
N OTE : Note the library's Encryption Key. The Encryption
Key is required when restoring the file to any
library.