QUASAR PAG - Manual (Page 2)

U5047A PAG QUASAR INSTRUCTION MANUAL U5047A PAG QUASAR INSTRUCTION MANUAL
SPECIFICATION
SECTION 2
2.1 PAG Quasar range:
Model No. 9726
◗ Two PAGlok connectors and two PP90 (2.1mm) connectors.
Model No. 9727
◗ Two Snap-on compatible connectors and two PP90 (2.1mm)
connectors.
Model No. 9752
◗ Two PAGlok connectors and two PP90 (2.1mm) connectors.
◗ Built-in Power Supply.
Model No. 9753
◗ Two Snap-on compatible connectors and two PP90 (2.1mm)
connectors.
◗ Built-in Power Supply.
2.2 Range of Batteries Charged:
◗ Nickel-Cadmium batteries having nominal voltages of between
4.8V and 14.4V, and nominal capacities of between 1Ah and 10Ah.
◗ Nickel-Metal Hydride batteries of reputable manufacture having
nominal voltages of between 4.8V and 14.4V, and nominal
capacities of between 1Ah and 10Ah.
◗ PAG Lithium-Ion batteries.
◗ Non-PAG batteries (other than Ni-Cd or Ni-MH) using appropriate
PAG Intelligent Charge Adaptor.
2.3 Battery Connections:
PAGlok connectors:
Patented professional connector compatible with all PAGlok batteries.
Incorporates self-cleaning military-type beryllium-copper leaf
contacts.
Snap-On compatible connectors:
Patented professional connector compatible with Li-Ion Time Batteries
(Models 9366 and 9383), and most Anton-Bauer batteries (excluding
Dionic batteries).
PP90 connectors:
Polarised connector suitable for 2.1mm coaxial DC power connectors.
NOTE: centre pin negative.
2.4 Main Charge Program:
◗ Auto Mode - automatically selects the correct charge current.
◗ Manual selection - 2A or 3A charge current.
◗ Li-Ion voltage-charge program only available with PAG intelligent
batteries or suitable PAG intelligent adaptor. PAG intelligent
batteries automatically over-ride the Auto Mode or Manual
selection, and control their own charge regime.
2.5 Recovery Charge:
This special program conditions the battery for a period of one hour.
The charger will then automatically enter the Main Charge program,
which will run until the battery is fully charged. This program also
recovers PAG Li-Ion batteries which have been over-discharged to the
point where the internal safety protection circuit has tripped.
2.6 Ancillary Charging Programs:
The following programs may be automatically entered after charging:
◗ Balancing Charge.
1.10 Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as the supply
cord or plug has been damaged, liquid has been spilled, the apparatus
has been exposed to rain or moisture, does not operate normally, or
has been dropped. In this event you should seek advice from your
nearest PAG Dealer, or direct from PAG Ltd., London, by telephoning
+44 (0)20 8543 3131.
3 4