QUASAR PAG - Manual (Page 3)

U5047A PAG QUASAR INSTRUCTION MANUAL U5047A PAG QUASAR INSTRUCTION MANUAL
◗ Self-adjusting Maintenance Charge (not applied to PAG Li-Ion
batteries).
2.7 Self Test Program:
The internal microcomputer constantly monitors the battery under
charge or process as well as the operation of the charger’s own
functions which will be shut down to a safe condition should any of
the tests fail.
2.8 Camera Power Supply (Models 9752 & 9753 only):
These models feature a power supply rated 13.5V to 15V DC, 3.7A
(50W nominal), and is intended for powering a camera only.
Connector: XLR-4 (F), pin 1 negative, pin 4 positive.
2.9 Mains Input:
100-250V ~. Frequency 47-63 Hz. Maximum power consumption 100W.
2.10 Output:
26V DC 4A peak.
2.11 Output Protection:
Charger protected against short circuit, open circuit, excess battery
voltage and reverse battery voltage.
2.12 AC Mains Failure Protection:
Should mains failure occur during a charging program, or whilst the
charger is connected, it will shut down to a safe condition.
2.13 User Interface:
The backlit LCD screen has a display area of 64mm x 15mm, which
displays 2 lines of text, with 16 characters per line.
The front panel incorporates a soft function switch for the selection
of programs and interrogation of charge data.
2.14 Safety:
Designed to comply with electrical safety standard EN60065 and
UL6500. NOTE: U.K. mains leads are fitted with a 1" fuse to BS1362
rated 5A as standard.
2.15 European Union Directives:
Complies with the following EU Directives:
◗ EMC Directive 89/336/EU.
◗ Low Voltage Directive 73/23/EU.
2.16 Operating Temperature Range:
0ºC to 40ºC (+32ºF to +104ºF).
2.17 Overall Dimensions:
Models 9726 & 9752:
72mm high x 135mm wide x 185mm deep (2.8" x 5.3" x 7.3" approx.).
Models 9727 & 9753:
80mm high x 135mm wide x 185mm deep (3.1" x 5.3" x 7.3" approx.).
2.18 Weight:
Models 9726 & 9752: 882g (1.94lbs approx.).
Models 9727 & 9753: 844g (1.86lbs approx.).
INSTALLATION
SECTION 3
3.1 All Quasar chargers are fitted with a mains input socket conforming to
CEE22 (IEC socket). This is situated on the back panel. Mains supply
connection to the charger should only be made using the standard
lead supplied with this equipment.
3.2 Quasar chargers have been designed for use on AC mains supplies
worldwide, and automatically accept supplies in the range 100-250V ~.
Mains supply frequency must be in the range 47-63 Hz.
3.3 Quasar chargers may be operated from a vehicle 12V battery using the
PAG Vehicle Battery-Power Converter, Model No. 9774.
3.4 PAG TECHNICAL SALES AND INFORMATION DESK:
For further information, contact the PAG Technical Sales and
Information Desk (London) on +44 (0)20 8543 3131, PAG USA
Technical Sales and Information Desk on +1 818 760 8265, or your
nearest PAG Authorised Service Centre. Alternatively, visit the PAG
websites at www.paguk.com or www.pagusa.com
5 6