Quatech SSCLP-300 User Manual
Page 36
6.2.1 QTPCI.EXE
Quatech's "QTPCI" utility supplies the information required when
modifying the serial port settings of the application. This program should be run
from real DOS, not in a Windows DOS box.
Figure 13 shows the Basic Mode display for the DSCLP-200/300 after the
"Q" key has been pressed. In this example, the DSCLP-200/300 uses I/O base
address FFA0 hex and IRQ 3. The hardware revision of the DSCLP-200/300 is
also displayed. Pressing the "N" key will show similar information for all
non-Quatech PCI devices in the system, including those devices integrated on the
motherboard.
The QTPCI program is capable only of displaying the PCI configuration. It
cannot be used to make changes.
Figure 13 --- QTPCI.EXE Basic Mode display
DSCLP/SSCLP-200/300 User's Manual
36