QUASAR V V-1303B - Manual (Page 8)

8 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Connections/ Initial Setup
(Ready to Play)
How to Connect
Initial Setup (Plug&Play)
For ANT./Cable
Connect the cable from
Antenna/Cable to the VHF/UHF
terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on your
cable box to the VHF/UHF
terminal on the unit with a RF
cable.
Please make all cable or antenna connections before plugging
into the AC outlet. Plugging the unit power cord into an AC outlet
starts auto channel and clock set.
VHF/UHF
IN from
ANT./CABLE
VHF/UHF
VHF/UHF
Cable TV
Converter Box
Connecting
IN from
ANT./CABLE
VHF/UHF
VHF/UHF
2 / 6 / 2002 WED 12 : 00PM
DST : ON
AUTO CLOCK SET
COMPLETED
SETT I NG : CH 1 0
If AUTO CLOCK SET IS
INCOMPLETE screen
appears, set the clock using
MANUAL CLOCK SET
procedure on next page.
Initial Setup (Ready to Play)
1
Plug the unit power cord into an
AC wall outlet.
Press POWER on the remote or
unit. The unit comes on and auto
channel and clock set starts.
• If you use a cable box, turn it on and set it to the
Public Broadcasting Service (PBS) channel in
your time zone. If you use a DSS reciever, it
must be turned off.
Settings are made
automatically. When setup is
done, this screen appears.
CH AUTO SET PROCEEDING
PROCEEDING
AUTO CLOCK SET
CANCEL : PRESS STOP KEY
3
2
WARNING:
Overtightening “Nut type” RF coaxial cables
may damage jacks. Finger tighten only.
PLEASE SET CLOCK BY
PRESS I NG ACT I ON KEY
AUTO CLOCK SET
I S I NCOMPLETE
UNIT