Quantum Audio SuperLoader 3A Series - Manual (Page 8)

8 Rack Mounting the Autoloader
SuperLoader™ 3A Series Quick Start Guide
Figure 3 Attaching Autoloader
Brackets
3 Using rack screws, attach a support bracket to the clip nuts on each rear rail (see
figure 4 .)
Tighten the screws just enough to hold the support brackets firmly against the rail
while still allowing the support bracket to be slightly shifted by hand. This shifting
will help facilitate the engagement of autoloader brackets as the autoloader is
installed in the rack. You will fully tighten the screws in step 8 .
Note: Be sure to attach the support brackets correctly; the side of the bracket with
only two holes should be secured to the rail.
Autoloader
Autoloader bracket
Screws (10-32 x 1/4 only)