Quantum Audio drive DDS-4 - Manual (Page 19)

Installing internal tape drives Collecting the Necessary Tools
19
4. Access the Inside of the Computer
See “Accessing the Inside of Your Computer” on page 26.
5. Mount the Drive into the Computer Mounting Bay
See “Mounting the Internal Tape Drive” on page 26.
6. Attach a SCSI Interface Cable
See “Connecting a SCSI Cable” on page 29.
7. Attach a Power Cable
See “Connecting a Power Cable” on page 30.
8. Complete and Verify Your Installation
See “Completing Your Installation” on page 31.
Collecting the Necessary Tools
Before proceeding with the installation, gather the tools you will need to install the internal tape
drive into the computer mounting bay. The following list identifies some of the tools you will need.
You may need additional items, depending on your installation requirements.
• Phillips screwdriver
• Flatblade screwdriver, if your computer uses flathead screws
• Torx screwdriver, if your computer uses torx screws
• Computer documentation, which you can refer to during the installation
Reviewing Drive Default Settings
Your internal tape drive comes with various default settings. These settings are configured using
jumpers and switches.
• The jumpers are located on the back of the drive, between the SCSI interface and power con-
nectors (see Figure 3 on page 20)
• The switches are located on the underside of the drive. If you change a switch setting, you
must turn the drive off and then on to have the new setting take effect (see Figure 4 on
page 21).
You may need to change these settings to suit your requirements. Review the default settings in
Table 2 on page 20 to determine whether they suit your requirements or need to be changed.
• If you do not need to change these default settings, skip to “Accessing the Inside of Your Com-
puter” on page 26.
• To change one or more settings, refer to the appropriate page in Table 2 on page 20.