Quantum Audio drive DDS-4 - Manual (Page 27)

Installing internal tape drives Mounting the Internal Tape Drive
27
4. Secure the drive in the mounting bay using two M3.0 metric screws on each side of the drive
(see Figure 5 on page 27). As Figure 6 on page 27 shows, the 3.5-inch drive has four screw
holes on the bottom and five on each side.
WARNING: Do not use screws longer than 4 mm; otherwise, you may damage the drive.
5. Proceed to “Connecting a SCSI Cable” on page 29.
FIGURE 5. Mounting an Internal Tape Drive
FIGURE 6. Mounting Holes for the Internal Tape Drive in a 3.5-inch Installation
41.3 mm
(1.63 in)
101.6 mm
(4.00 in)
101.6 mm
(4.00 in)
94.0 mm
(3.70 in)
3.8 mm (0.15 in)
13.0 mm (0.51 in)
2 places
5.0 mm (0.196 in)
2 places
90.0 mm
(3.54 in)
2 places
70.0 mm
(2.75 in)
6.0 mm
(0.24 in)
31.0 mm
(1.22 in)
146.0 mm
(5.75 in)
41.2 mm
(1.62 in)
60.0 mm
(2.36 in)
2 places
21.0 mm (0.83 in)
2 places
Side View Bottom View
M3.0 x 4 deep min.
(10 places)
M3.0 x 4 deep min.
(4 places)
Note: Tolerance for all dimensions is 0.25mm (0.01 in)