QSC Audio SRA 2422 - Manual (Page 23)

23
CONNECTIONS-
Outputs: Binding Posts
Using the Binding Posts
The binding posts support several connection methods;
banana plugs, spade lugs, or direct wire connection.
European models do not support the use of banana
plugs.
If using banana plugs, plug into the binding post
directly.
If using spade lugs, refer to the diagram, below, for
acceptable dimensions of lug.
If connecting the cable directly, strip about 1/2-inch of
insulation from the ends and neatly twist any loose
strands. Loosen the retaining nut fully, insert the wire,
and tighten. Do not overtighten! Maximum wire gauge
is #10 AWG (2.58 mm diameter).
WARNING! Use
proper speaker
wire. Stereo or
Parallel Mode: Use NEC
Class 2 wiring. Bridge
Mode: Use NEC Class 1
wiring. Refer to local and
national electrical codes to
assure code compliance.
Binding post outputs on the rear panel.
Continued, following page.....
13 mm
1/2”
2.58 mm max. diameter
#10 AWG maximum
19 mm
3/4”
European models do not
have banana plug feature.
6.3 mm minimum
0.25” minimum
12.9 mm maximum
0.51” maximum