QSC Audio SRA 2422 - Manual (Page 26)

26
CONNECTIONS-
Outputs: Speakon connectors
Stereo or Parallel Modes
Stereo and Parallel modes
use one cable for each
channel. Each cable con-
nects to its respective output
connector and speaker.
CH1’s Speakon can be used
with a four conductor cable
for carrying both outputs.
The required signal splitting
would take place at the
speaker-end of the cable.
Bridge Mode
Bridge Mode Speakon connection uses CH1’s Speakon only. Pin 1+ is the positive signal and Pin 2+ is the
negative signal. NOTE! Make sure the speaker-end is wired according to its specifications. The diagram
below assumes cabinet to be wired pin1+ and pin 1-. Verify proper connections are made!
WARNING! Use proper speaker wire.
Stereo or Parallel Mode: Use NEC Class 2 wiring.
Bridge Mode: Use NEC Class 1 wiring.
Refer to local and national electrical codes to assure code compliance.
2 wire Speakon cables
Speakon cable wiring
Speakon cable wiring
2 wire Speakon cable