Topcom BUTLER 1250 - Manual (Page 100)

100
0 + 1 Record OGM 1 None
0 + 3 Record OGM 2 None
0 + 7 Set VIP code None
0 + 8 Set number of rings None
0 + 9 Set date/time None
+ OK Erase all messages Erase current message
7.4 Exiting Answering Machine Menu
When you are in the answering machine menu, you cannot make telephone calls. You can only
operate the answering machine. If you would like to exit the menu, press the OK key.
If the machine receives an internal or external call, it automatically exits the answering machine
menu.
Note: When you exit the answering machine menu, the display information is changed. During this change,
the symbol will blink. After a moment, the total/new messages (MSG XX/YY) is changed.
7.5 Outgoing Messages
Two outgoing messages of a maximum of 2 minutes can be recorded (OGM1 and OGM2).
• Outgoing message 1 for the answering function and possibility for callers to leave messages
• Outgoing message 2 for the answering function without allowing callers to leave any
messages on the machine.
7.5.1 Recording outgoing messages (OGM 1 or OGM 2)
• Press the Programming Key twice to go to the answering machine menu (see
'Answering Machine Menu').
• Press the '0' key.
• Then press:
- Key ‘ ’ to record Outgoing Message 1.
- Press ‘ ’ to record Outgoing Message 2.
• A voice will say which outgoing message is being recorded.
• After the beep, say your outgoing message.
• Press the Stop key
to stop recording.
Note: The recording cannot exceed 2 minutes. If no outgoing message is recorded, the standard outgoing
message is used:
• Outgoing message 1: ‘Please call later’.
• Outgoing message 2: ‘Please call later’.
7.5.2 Checking the Outgoing Message
To check the outgoing message now set:
• Press the Programming Key
twice to go to the answering machine menu (see
'Answering Machine Menu').
• Press the key.
Note: To stop playback, briefly press the Stop key .
Butler 1250
B1250_NL_F_D_GB 25/3/02 3:09 pm Pagina 100