Thermador VTN420B User Manual
Page 15
Page 15
From Control
Panel
Motor connector
VTN 420 or VTN 620
Wiring the HOOD with an
IntegralVentilator:
Warning:
Turn off electricity at
the service panel before wiring the
unit.
1.
Connect the Integral Ventilator
molex plug connector to the
connector present inside the
hood as shown in Figure 9 or
Figure 10
.
2.
Remove the j-box cover as
shown in Figure 11.
3.
Remove 1 of 2 knockouts and
install 1/2 conduit connector
in j-box.
4.
Run black, white, and green
wires (#14 AWG) in 1/2 conduit
from power supply to j-box.
5.
Connect black, white, and
green wires from power supply
to black, white, and green/
yellow wires in j-box
respectively.
6.
Close j-box cover.
Final installation steps
7.
Only HSB30 and HS30 Series
hoods: fit the side mould on the
right side, and fix it with 3
screws as shown in Figure 12.
8.
Replace filters as described in
the Care & Use section of this
manual.
Turn power on at service panel.
Check operation of the hood.
Figure 10
Figure 11
From
control
panel
Figure 12