Toshiba CIX - Manual (Page 125)

ADM/DSS Console
DSS Console
Strata CIX and CTX IPT/DKT Telephone 03/05
111
DSS Console
The Direct Station Selection (DSS) console
operates alongside an IP or digital telephone
to provide 60 additional buttons. The
DKT3000-series telephones requires a 3000-
series DSS; the 2000-series telephone
requires a 2000-series DSS. A DDSS3060
example is shown right. The IDSS2060 (not
shown) looks similar and has the same
button/LED functions.
Note The IP telephones do not support a
DSS console when connected to a
Strata CTX.
The 60 flexible feature buttons can be
assigned as CO line, extension, DSS, One
Touch Speed Dial or any other flexible
feature.
The DDSS3060 console uses dual red and
green LEDs to show call and feature status.
Note Button numbers in the above figure are examples only.
DSS Buttons
DSS buttons can appear on both the ADM and DSS Console. Each DSS button is
associated with a particular station in your telephone system. DSS buttons can transfer
an outside call to the associated station or make a direct call to the associated station.
The DSS LED lights steady red when the station associated with the DSS button is
ringing, busy on a call, or when the associated station is idle, but all appearances of the
station’s extensions are busy or in-use by other stations. When the associated DSS
button is in the Do Not Disturb mode, the LED blinks red at a slow rate.
DSS buttons cannot call station Phantom extension numbers, Distributed Hunt Group
Directory Numbers, or ACD Groups. DSS buttons may be configured as One Touch
Buttons that may be programmed to call these destinations.
The LED colors described in this section apply to the DADM3020 and DDSS3060.
Described Flash conditions apply to all DSS console models and the DADM.
209
208
207
206
205
204
203
202
201
200
219
218
217
216
215
214
213
212
211
210
229
228
227
226
225
224
223
221
221
220
239
238
237
236
235
234
233
232
231
230
249
248
247
246
245
244
243
242
241
240
NT
AC
257
256
255
254
253
252
251
250
2039